Charge internal battery
When switched on and connected to the target device via Bluetooth, the internal battery is designed for 18 hours of operation. Alternatively, up to 6,000 scan cycles are possible, depending on the decoder board setting.
At the end of the day, perform the following steps:
- Pull the TRIGGER or CLIP PAD with scanner off the cuff. Use the tab provided for this purpose.
- Place the Smart Watch HS 50 with pad in the charging station.
- The charging process starts automatically when the charge level is less than 80 %.
 |
There must be no objects between the charging station and the pad. The Smart Watch HS 50 does not need to be switched off, it switches off automatically at the start of the charging process. |
| Load status | Display | LED when charging |
|---|---|---|
| <10 % | Crossed out battery | red pulsating |
| <25 % | Charging icon (battery with flash) and display finger | red pulsating |
| <85 % | Charging icon (battery with flash) and display finger | yellow pulsating |
| <100 % | Charging icon (battery with flash) and display finger | green pulsating |
| 100 % | Display finger | green glow |